This product is a composite material made of an organic polymer and inorganic powder was made of two-component waterproof coating is a new type of waterproof material, both with high elasticity properties of organic materials, inorganic materials also has water resistance, weather resistance, durability etc. and a supporting reinforced polyester fabric used to form high strength and tough waterproof layer. Sink is metal and concrete structures most likely to occur where leakage, the water around the mouth unglued, sink perforation, rust can cause water leakage, ordinary waterproof material is difficult to meet long-term needs. This product is specifically designed for the development of the tank, is the preferred water tank, ditches, water pipes and so on. 2.1 Excellent adaptability, can be applied directly on a variety of materials and water-based surface layer. 2.2 excellent weather resistance, fatigue resistance, high temperature performance, can be directly exposed to the sun without protective layer, high temperature up to 140 ℃. 2.3 excellent water resistance and adhesion, the substrate to achieve 100% bonding, to form a seamless waterproofing system. 2.4 Excellent UV, chemical resistance, anti-aging properties. ?? 5.1 Construction 5.1.1 Pretreatment first working face carefully clean the construction, must ensure that the base surface is smooth, no loose firmware, no rust, no oil, dust, out of water, so that it remains clean. To base loose firmware replacement or reinforcement must be done. 5.1.2 For the base surface has rusted, need to polish metal which turns rust color, then use the fruit Seoul good corrosion protection system supporting anti-corrosion pretreatment. 5.1.3 uneven base surface, the tone thick cement mortar, leveling with a knife once approved, block grant thickness of less than 5mm, pay attention to every block grant should not be too thick, cracks need to use this product to make an additional layer. Yang angle seat arc process, wall pipe, the water port and other complex parts also need to do additional layer processing. 5.2 Construction Preparation 5.2.1 to determine the width of the site that you need to do waterproofing and waterproof layers and a good cut respective reinforced polyester fabric width. 5.2.2 should be used with paint stir, but there is no separate water distribution or accessories directly brushing jobs. 5.2.3 construction can brush, roller and blade coating manner, should prepare the relevant work tools, while making the necessary labor protection measures. 5.3 Construction Technology (three-coat a fabric) 5.3.1 Ingredients: water slurry formulation ratio by weight of liquid material: powder = 10: 3.5. After opening the waterproof coating liquid feed drums stir it first, then press the proportion of reclaiming water slurry preparation, the ratio of good material is poured into another container stir until the compound does not contain aggregate (mixing time of 3 minutes , not the best hand mixing). Before mixing, the waterproof coating liquid and powder material stored in a cool place Shenzhen, Seoul good fruit waterproofing works Address: Longgang District, Shenzhen, Guangdong Province, Longgang Avenue, Building 1066 Seoul good fruit Tel: 18033060607 Alibaba store: http: // golkia. 1688.com/